TPMS ( Tire Pressure Monitoring System ) Activation. 

<script async src="https://pagead2.googlesyndication.com/pagead/js/adsbygoogle.js?client=ca-pub-8607523270785176"
     crossorigin="anonymous"></script>
=>  Turn the ignition switch to the ON position.
<amp-auto-ads type="adsense"
        data-ad-client="ca-pub-8607523270785176">
</amp-auto-ads>

=> Position the special tool against the Left Front (FL) tire sidewall at the tire valve stem.
Use  TPMS Special Tool { Tire Pressure Monitor (TPMS)}

NOTE: There are many tools like VT-36,  ATUL TS – 401 etc..,


 

=> After positioning special tool it  should provide feedback in the form of a flashing green light and a beep sound for each successful response from a tire pressure sensor.

=> This sensor feedback may not always be present, do not rely on it as a confirmation that the module heard a particular sensor.

=> If a sensor does not respond to the special tool move the vehicle to rotate the wheels at least one-fourth of a turn and attempt to activate and position the same sensor again.

=> If the sensor still fails to activate, attempt to activate the sensor with the vehicle doors open mode

NOTE:-  U can also activate the tire pressure sensor.by using customer activation tool if applicable.

=> Press the test button on the special tool to activate the sensor.

=> U should Activate the sensor minimum of  2 times to be successful program-me.

NOTE:- If u still facing the activation problem further u can check the  vehicle CONTROL MODULE wiring for damage signs, Software corruption, or even CONTROL  MODULE Failure.

https://www.facebook.com/hariharan.r.54390 

Location: Salem, Tamil Nadu, India

Comments

Post a Comment

Popular posts from this blog

Ford Service Due Light Reset

Image
<script async src="https://pagead2.googlesyndication.com/pagead/js/adsbygoogle.js?client=ca-pub-8607523270785176" crossorigin="anonymous"></script>   Here i show you how to reset your FORD service due light. <amp-auto-ads type="adsense"         data-ad-client="ca-pub-8607523270785176"> </amp-auto-ads> => First Get into Vehicle and close all the doors, => Then switch on the ignition and  simultaneously press BRAKE and ACCELERATE PEDALS. => Hold it for 30 - 40 seconds or untill Light goes off. => After light goes off switch off the ignition, wait 10 second. => Then start the vehicle and check it.  Ford service due light has been resetted successfully. https://www.facebook.com/hariharan.r.54390
Read more

2 Stage Unlocking Feature In a Car

Image
<script async src="https://pagead2.googlesyndication.com/pagead/js/adsbygoogle.js?client=ca-pub-8607523270785176"      crossorigin="anonymous"></script> Hi everyone in this blog u going to see a HIDDEN FEATURE of Centre locking in a CAR REMOTE . All u know only there is lock and unlocking feature is only available in remote, Beyond that there is a hidden feature i.e   2 Stage Unlocking Feature. To enable and dis-able this feature there is simple method the procedures are below, => First close the all DOORS including HOOD and BOOT, =>Simultaneously press and hold LOCK and UNLOCK button on remote upto 5SEC., =>After successful programming your car HAZARD LAMP will blink TWICE automatically, =>This indicate that 2 STAGE UNLOCKING FEATURE was enabled.  https://www.facebook.com/hariharan.r.54390
Read more